Kouros 2013



01

The model, “Bill” hits the pose. The angled posing platform distributes his weight across his back, enabling to essentially stand throughout the molding process.

02

The Alginate impression material is applied.

03

Cotton fibers are quickly embedded into the wet alginate. The alginate sets in about 7 minutes, after which the excess cotton is removed. The remaining cotton will grab the plaster gauze.

04

The plaster shell (mother mold) is applied.

05

The one-piece negative mold is removed.

06

Ultracal-30 is layered into the mold.

07

Artist Philip Hitchcock poses next to the “raw pull.”

08

A phallus is cast from a model.

09

The phallus is fit into place.

10

The view from the front. The piece is paint and hardware ready!

11

The finished piece KOUROS 2012. (Be sure to check out the video!)